[Prev][Next][Index][Thread]
Re: How with no RF ground
Bob, wrote....
snip....
> I took the plate off the wall in my bathroom to look at the
> wiring when I noticed that the ground cable had broke away from
> the wall socket long ago. So in my testing, I actually never
> had an RF ground at all! I do not understand how I could have
> gotten the output I did without this ground.
Quoting Malcolm Watts <MALCOLM-at-directorate.wnp.ac.nz>:
> I've done it too at low power. I think the ungrounded wiring is
> acting like a counterpoise (capacitive coupling to earth). But
> perhaps someone else could set me straight on this. I wouldn't
> attempt this at higher power. Sooner or later the wiring will
> break out. You could end up with a fire.
I forgot capacitive coupling, which requires a bit of surface
area to dissipate the energy. My experiments point more towards
the possibility of wiring break out and the resulting fire
hazard, even at low/moderate power levels.
Richard Quick
... If all else fails... Throw another megavolt across it!
___ Blue Wave/QWK v2.12