[Prev][Next][Index][Thread]
Re: SPICE, Solid State Suk's, and Slugs (fwd)
From: Scott Stephens[SMTP:stephens-at-enteract-dot-com]
Sent: Tuesday, December 23, 1997 1:33 PM
To: Tesla List
Subject: Re: SPICE, Solid State Suk's, and Slugs (fwd)
At 11:50 PM 12/22/97 -0600, you wrote:
>I have been pursing the same approach, although at a somewhat higher energy
>level: 40 kJ to produce a 3 MV pulse lasting many microseconds to allow the
>spark to propagate many meters. My problem is insulation and mechanical
>issues.
>Pulse transformers are used a lot in the Capacitor discharge spot welding
>business. Imagine a machine to weld an 8 foot wide section of steel
>reinforcing mesh, i.e. 48 welds simultaneously at several kAmps each.
>Charge a cap up to a few kilovolts, run it through a 100:1 step down, and
>there is your megaamp discharge.
Think you could do a before/after radiation check for alpha radiation
emission from neutron activation? Rich Hull and other fusion researchers
might find the results interesting.
>For the impulse transformers, they typically use a bar core, because the
>pulse lasts such a short time, the magnetic field doesn't have time to
>propagate out the end of the bar, before it collapses due to the load
>power.
What is the propagation velocity of the magnetic field? Should be quite high
I would think. Anyways, the (reluctance?) or permiability difference between
air and even pwdrd iron (150) would make leakage negligable.