[Prev][Next][Index][Thread]
FW: 2 Layer Secondary.
----------
From: Bert Hickman [SMTP:bert.hickman-at-aquila-dot-com]
Sent: Friday, February 20, 1998 8:52 AM
To: Tesla List
Subject: Re: 2 Layer Secondary.
Tesla List wrote:
>
> ----------
> From: Zuma [SMTP:mwise-at-ns.sosis-dot-com]
> Sent: Thursday, February 19, 1998 2:45 AM
> To: tesla-at-pupman-dot-com
> Subject: 2 Layer Secondary.
>
> I understand that if I wind two indentical windings, one on top of the
> other. That it will successfully lower the resistance thus leaving the
> frequency, capacitance and the inductance alone, Corrrect? With the
> lowered resistance wouldn't allow for easier voltage flow or am I just
> way off base here? The reason I ask is that I am going to attempt a
> small 2 layer coil specifically for indoors. I am going to use a 3.25"
> o.d. pvc pipe, with a 3:1 or a 4:1 ratio to height. The power supply,
> though small, is a 7.5kv-at-60ma. I am going to use an existing primary I
> have from a 4" coil. On the 4" coil it had 1" spacing from secondary to
> primary. Given the size of my new coil, I should end up with abou 1.5"
> spacing between the two. The only thing I haven't decided it the size of
> wire to use on the secondary. I have about a 7-8lb spool of 22awg magnet
> wire that I bought about 2 months ago, I bought it to wind my 6.25" coil
> and I still have a good 7lbs at least, the spool size was originally a
> little over 10lbs. I am almost tempted to go ahead and use the 22awg
> because it is readily availible, but on the other hand I could have a
> better performing coil if I go with 24awg or even better 28awg. I am not
> looking for extreme output here, I would say probably about 12" or a max
> of 18" considering it would defeat the purpose of having a small scaled
> indoor coil. Given the input power what do any of you think this coil is
> capable of? If I can obtain a small quantity of 24 or 28awg wire in a
> size of no more than 2 or 3 lbs, I will most definately wind a coil
> using a smaller gauge wire. But given what I got more than likely I will
> just use 22awg.
>
> Another qustion I wanted to ask. Any of you that have wound
> multi-layered coils, Was there an increase in output at all? I would
> think that even though that most of the calculations will reside at what
> they are set at and the resistance will drop. Would the lower resistance
> encourage a longer spark? Now I am not talking like huge differences, I
> am talking about output in the range of a few inches.
>
> Chris
Chris,
Lower resistance will let current flow through the secondary more
efficiently, so that you will have less energy loss in heating up the
secondary winding, and more going into streamers. For the small coil
you're describing, a single layer coil of #22 or #24 should suffice
without the added work of making a 2-layer secondary.
-- Bert --