[Prev][Next][Index][Thread]
secondary coil form
-----Original Message-----
From: D.C. Cox <DR.RESONANCE-at-next-wave-dot-net>
To: Tesla List <tesla-at-pupman-dot-com>
Date: Wednesday, July 01, 1998 11:28 AM
Subject: Re: secondary coil form
to: Ben
Cut it off and square it up in a lathe prior to winding.
DR.RESONANCE-at-next-wave-dot-net
----------
> From: Tesla List <tesla-at-pupman-dot-com>
> To: 'Tesla List' <tesla-at-pupman-dot-com>
> Subject: secondary coil form
> Date: Tuesday, June 30, 1998 10:05 PM
>
>
> ----------
> From: Ben McMillen [SMTP:sammac-at-cobweb-dot-net]
> Sent: Tuesday, June 30, 1998 5:02 PM
> To: Tesla List
> Subject: secondary coil form
>
> I've been wanting to build a coil for a while and I had a piece of 8 in.
PVC
> drain pipe laying around the basement so I decided to use it for my
> secondary coil form. One end of it is flared to allow several sections to
be
> fitted togehter. My question is: Will this flare affect the performance
of
> the coil? Cutting it off is not a problem. Thanks for any help.
>
> Ben McMillen
>