[Prev][Next][Index][Thread]
Re: 60 Gaps at 4 mil Data (fwd)
---------- Forwarded message ----------
Date: Sat, 11 Jul 1998 13:15:12 -0500 (CDT)
From: Larry Bud Melman <gasman-at-althea.a-line-dot-net>
To: Tesla List <tesla-at-pupman-dot-com>
Subject: Re: 60 Gaps at 4 mil Data (fwd)
> I was finally able to get my 60 gap, by 4 mil spacing, spark gap put
> together. It's quenching was better than my 7 mil gap but not by any great
> amount. My old gap (7 mil) gave good quenching with a coupling of 0.1242.
> The 4 mil gap goes to 0.1475. With breakout, it will go to 0.1753 for a
> first notch quench. So it is better, but not by any giant degree. The is a
> picture of the 4 mil spark gap at:
>
> www.peakpeak-dot-com/~terryf/tesla/gap.jpg
>
> It has 60, 2 inch long, 1/2 inch copper pipe sections epoxied to an oak base
> in two rows. I used 4.0 mil paper strips to space the sections while the
> epoxy cured. I simply placed a section of pipe across the two rows to
Well...what sort of coil were you using this gap on?? I'd be
curious how well it worked for a high-power coil. (Might save me from
building a RSG.... :-)
Clay