Re: Rolled PE Caps

• To: tesla-at-pupman-dot-com
• Subject: Re: Rolled PE Caps
• From: "Steve Young" <youngs-at-konnections-dot-com> (by way of Terry Fritz <twf-at-verinet-dot-com>)
• Date: Fri, 09 Apr 1999 23:11:54 -0600
• Approved: twf-at-verinet-dot-com

Kevin,

If you bring the foil out the edges of the roll instead of the ends, so you
have a very low impedance connection to your plates, then foil is just as
good as flashing.  Even for end connections, the hassle and extra cost of
flashing compared to heavy duty foil is probably not worth it, in my
opinion.

--Steve Young

----------
> From: Tesla List <tesla-at-pupman-dot-com>
> To: tesla-at-pupman-dot-com
> Subject: Rolled PE Caps
> Date: Thursday, April 08, 1999 12:30 PM
> 
> Original Poster: "Kevin Wahila" <knw2-at-lehigh.edu> 
> 
> What would be the difference if you used aluminum foil rather than
aluminum
> flashing as the plates in a rolled poly cap?  It would just be so much
easier
> to roll.  Would it perform as well though?
>  
> Kevin Wahila
> 
> 

• Prev: Re: Measuring inside a coil
• Next: Re: MMC size: (Was: Re: Success with PP Multi-Mini Cap)
• Index(es):
  • Main
  • Thread