[Prev][Next][Index][Thread]
RE: caps an the resonant freq.
thank you thats what I thought, now I just need to know what indutance I am
to base my calulations on the primary or secondary, this I know is a trivel
question and I have waited to ask until I read everything I could find but
the answer is not jumping out at me.
-----Original Message-----
From: Tesla List [mailto:tesla-at-pupman-dot-com]
Sent: Tuesday, February 09, 1999 10:17 PM
To: tesla-at-pupman-dot-com
Subject: Re: caps an the resonant freq.
Original Poster: "Dr. Resonance" <DR.RESONANCE-at-next-wave-dot-net>
to: Kerry
1 mil = .001 inch, so 6 mil poly is .006 inches. You need 60 mil poly or
060 inch thick for a capacitor.
Regards,
Dr.Resonance-at-next-wave-dot-net
----------
> From: Tesla List <tesla-at-pupman-dot-com>
> To: tesla-at-pupman-dot-com
> Subject: caps an the resonant freq.
> Date: Tuesday, February 09, 1999 11:21 AM
>
> Original Poster: Kerry Jarrell <Kerry-at-apprentice-dot-com>
>
> well I am reading the articals in the arcives about caps, and I read some
> people are using .06" poly, or it reads 6 mill poly, my question is, is
it
> hundreths of an inch or thousands that i should look for I got 2 sheets
of
> hdpe of .03" thickness and I just want to make sure that I am not wasting
my
> time building the caps with the wrong thickness of plastic, the other
> question, I have is a simple one but I can not find it on the web sites
at
> least not yet, the resonant freq. that you base your calculations on for
the
> cap, is it the iductance of the primary or the secondary, or a combo of
> both..... I find some answers but there not clear, I have built some
coils
> in the past but i did not have the background to do the math not I have
the
> background I want to do math and see how close I can get to what I am
> calculating.
>
> kerry
>