Re: New LTR Stuff

• To: tesla-at-pupman-dot-com
• Subject: Re: New LTR Stuff
• From: Terry Fritz <twftesla-at-uswest-dot-net>
• Date: Thu, 10 Jun 1999 07:23:57 -0600
• Approved: twftesla-at-uswest-dot-net
• Delivered-To: fixup-tesla-at-pupman-dot-com-at-fixme
• In-Reply-To: <3.0.3.32.19990609181243.011a5a94-at-mail.clara-dot-net>
• References: <4.1.19990607211514.00a02d40-at-pop.dnvr.uswest-dot-net>

At 06:12 PM 6/9/99 +0100, you wrote:
snip......
>>sync03.jpg - The back of the rotor showing the 3/8-20 bolt, the poly disk,
>>and the tungsten electrodes.  I hope the disk does not melt but this gap
>>will see fairly easy service so it should be ok...
>
>Superb photos again terry,
>	How are the electrodes held into the disk?
>bob golding
>

I drilled 1/8 inch holes through the poly on a drill press and the holes
hold the rod very snugly just from friction.

	Terry

• New LTR Stuff
• From: Terry Fritz <twftesla-at-uswest-dot-net>

• Prev: Last post
• Next: Re: Vtop vs coil length
• Index(es):
  • Main
  • Thread