[Prev][Next][Index][Thread]
Re: Neonics wonderland!!!!
to: John
Good questions. I think it would depend a lot on the spark gap setting. We
usually run ours close --- 2 or 3 gaps set around .060 or .070 each with a
blower fan behind them. I suppose one could freeze it on a storage scope
and calculate the area under the curve as an average value. It is weird
because of their current control link, but primary power should equal
perhaps 110-115% of secondary power under operational load. Just a guess.
How's your health?? Missed you this year but will get out there again next
winter. I hear Nick at Highway Electronics might be selling off a lot of
goodies this winter as he's really getting old --- somewhere around 87 I
think.
Regards,
Dr.Resonance
-----Original Message-----
From: Tesla List <tesla-at-pupman-dot-com>
To: tesla-at-pupman-dot-com <tesla-at-pupman-dot-com>
Date: Friday, June 11, 1999 3:27 PM
Subject: Re: Neonics wonderland!!!!
>Original Poster: "John H. Couture" <couturejh-at-worldnet.att-dot-net>
>
>
> Dr Resonance, All -
>
> Would you hazard a guess as to what wattage the 15 KV 60 ma NST's would
>produce in Tesla coil operation? This is not a trick question. I have been
>contemplating this question for some time but so far have not come up with
a
>reasonable answer.
>
> John Couture
>
>---------------------------
>
>-----Original Message-----
>From: Tesla List <tesla-at-pupman-dot-com>
>To: tesla-at-pupman-dot-com <tesla-at-pupman-dot-com>
>Date: Wednesday, June 09, 1999 10:59 PM
>Subject: Re: Neonics wonderland!!!!
>
>
>>Original Poster: "Dr. Resonance" <Dr.Resonance-at-next-wave-dot-net>
>>
>>to: Barry
>>
>>We carry 15 kV 60 mA units for $50.00. Also, your warranty won't apply
if
>>a NST is used in Tesla coil service. NST's are manufactured to provide 15
>>kV for a few seconds and then drop back to around 800 volts and provide a
>>steady current source.
>>
>>Regards,
>>
>>Dr.Resonance
>>
>
>
>