[Prev][Next][Index][Thread]
RE: Coil Winder (fwd)
---------- Forwarded message ----------
Date: Mon, 11 Oct 1999 10:18:44 -0400
From: "Lau, Gary" <Gary.Lau-at-compaq-dot-com>
To: 'Tesla List' <tesla-at-pupman-dot-com>
Subject: RE: Coil Winder (fwd)
Last night I wound a 6" secondary from a 10 lb spool of #22 AWG. After
reading the below post, I decided to try spooling the wire off the end of
the reel with the reel flat on one side on the floor, rather than fitting
the reel with an axle. It worked great! Plus, it avoids the problem of the
reel's inertia causing it to unwind after you stop the coilform. There was
no clumping or other problems. I suppose one's reel must be in good
condition with a smooth edge all around so that there are no snags, but for
me, it worked much better, and I was able to do it without a second pair of
hands. Thanks for the tip!
Gary Lau
Waltham, MA USA
In a message dated 10/10/99 4:32:01 AM Central Daylight
Time,
tesla-at-pupman-dot-com writes:
<< But the
professional way is to set the spool on edge and let the
wire twirl
off the end of spool. I just guide the wire by hand,
except on very >>
John,
Why? Especially with a large spool, doesn't that allow the
wire to fall from
the top of
the spool, clump up and maybe even fall over the rim of the
spool? Seems like
a
small point because it probably is. All the pictures I have
seen of factory
coil winding
machines show the spool horizontal and above. That's what I
saw when I toured
the Thordarson plant in Chicago, c. 1942.
Happy day,
Zeke