Re: winding motors

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Matt Skidmore by way of Terry Fritz <twftesla-at-qwest-dot-net>" <fox-at-gwydion.woozle-dot-org>

i have a small motor that is like 2 rpm and one that is 4. the problem is
they only have a small 1/4 inch stub that comes out of them. how would i
use that to hook up to a 5/16 rod thats holding the coil?

-matt

On Wed, 23 May 2001, Terry Fritz wrote:

> Hi Matt,
> 
> I get like 1 or 2 RPM motors from digikey.
> 
> www.digikey-dot-com
> http://info.digikey-dot-com/T012/V4/283.pdf
> 
> They are kinda pricy at $26 but they work great
> 
> Cheers,
> 
> 	Terry
> 
> 
> At 04:37 PM 5/23/2001 -0700, you wrote:
> >i was wondering if you could direct me to some place where i could find
> >motors or gear reducers suitable for coil winding. im no so conserned
> >about winding the coil but as keeping it rotating as the epoxy dries. i
> >started on a new 8 inch diameter coil tonight and found it rather hard to
> >keep it spinning long enough for the epoxy to cure. thanks
> >
> >-matt
> >
> 
>