[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Voltagee measurement
Original poster: "Gregory Hunter by way of Terry Fritz <twftesla-at-qwest-dot-net>" <ghunter31014-at-yahoo-dot-com>
Try applying mains current to the secondary winding
and reading the voltage on the primary. I expect where
you live the mains is 240VAC/50Hz? Apply that to the
high voltage winding and use an ordinary pocket
voltmeter to read the voltage on the primary winding.
Should only be a few volts AC due to the big
step-down. This will give you the turns ratio which
will give you reasonable guess at the high voltage
output when it's hooked up the other way round.
Greg
http://hot-streamer-dot-com/greg
--- Tesla list <tesla-at-pupman-dot-com> wrote:
> Original poster: "Kamil Kompa by way of Terry Fritz
> <twftesla-at-qwest-dot-net>" <tcmail-at-poczta.fm>
>
> Hi !
>
> I have a trouble with a transformer. I don't know
> it's parameters, so I
> want to measure voltage
> of the transformer (i think 5 to 20 kV). How can I
> do this?
> I found that spark apears between the electrodes
> connected to the
> transformer when the gap is about 15mm (between
> sharp nails) and about 6mm
> gap is required when electrotes are two spheres (no
> sharp edges).
> I know that breakdown in air is about 30V per
> 0.025mm, but which distance
> schould I use for accountings (6mm or 15mm)?
> I also noticed that when nails aore little wider
> than 15mm on the top of
> one of them appears corona. (sparks striking to the
> air in the direction of
> the other nail). There is no corona when I use
> spheres separated with more
> than 6mm of air.
> Could you tell me something about the output voltage
> of my transformer
> having this data?
> Thanks for all answers.
>
> Kamil Kompa
>
>
>
__________________________________________________
Do You Yahoo!?
Listen to your Yahoo! Mail messages from any phone.
http://phone.yahoo-dot-com