Re: Voltage Tripler and MOT's

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Sean Taylor by way of Terry Fritz <twftesla-at-qwest-dot-net>" <taylorss-at-rose-hulman.edu>

If you're coil isnt DC already, which it doesn't sound like it, it will have
to be after using a tripler.  A tripler will give you a DC output rather
than AC, so you'll run into problems there.  I would just try to get more
MOTs to hook in series so that the voltage increases.

----------------------
Sean Taylor
The Geek Group
G-2 #1204
Because the geek shall inherit the Earth! (c)
www.thegeekgroup-dot-org



----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Wednesday, April 17, 2002 9:04 PM
Subject: Voltage Tripler and MOT's


> Original poster: "Gregg Adams by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<network-at-nexband-dot-com>
>
> Hello all,
>     Has anyone had much luck with a voltage tripler on a MOT power
> supply?  If so, what size/type caps were used?  The reason I ask is
> because I have to run a very narrow spark gap that tends to power arc
> quite often unlike the 15kv NST's I used to use.  Opening the gap only
> causes it not to fire.  I am running this gap on a fairly
> powerful "sucker" vacuum motor with brass electrodes.  Would bigger
> electrodes help?  I was told by a good source that I needed more caps but
> it'll be a couple of months before I receive my geek caps and I'll go
> crazy waiting that long:)  So, am I on the wrong road with the voltage
> tripler or would that help my gap?
>
> Thanks much,
> Gregg Adams
>
>
>
>