[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: Need Formula for length of spiral
Original poster: "Steve Greenfield by way of Terry Fritz <twftesla-at-qwest-dot-net>" <alienrelics-at-yahoo-dot-com>
This fits right in with my r^2 theory.
Mmmm... universal donut...
Steve Greenfield
--- Tesla list <tesla-at-pupman-dot-com> wrote:
> Original poster: "Pete Komen by way of Terry Fritz
> <twftesla-at-qwest-dot-net>" <pkomen-at-zianet-dot-com>
>
> Sorry Jim, but the r^2 doesn't make sense to me. I
> suggested that the
> length of the wire is PI * Average diameter * number
> of turns. Take the
> case of three turns: the center turn length is PI *
> Diam., the outer turn is
> PI * (diam + delta); the inner turn is PI * (diam -
> delta). Add them all
> together and the + and - PI * delta terms cancel
> leaving 3 * Diam * PI.
>
> R^2 gives units of area (a unit of length squared).
> For a close wound coil
> the area of the windings divided by the width of the
> wire would give a close
> approximation of the length but not r^2. Note that
> the width is arbitrary.
>
> You said, "You know that the sum of all areas of the
> rings is the area of
> the circle,
> which is proportional to r^2, so therefore, the sum
> of the circumferences
> must also be proportional to r^2."
>
> I agree with the first part, but the conclusion is
> wrong. Consider your
> painting with three wide rings of constant width.
> The total length of the
> rings is proportional to r^2/width (of the ring).
> Since the width term is
> not fixed your conclusion is invalid. In any circle
> of radius R, any
> arbitrary number of rings could fit, thus making the
> total length (or
> average circumference) of the rings arbitrarily
> different from R^2.
>
> Regards,
>
> Peter Komen
__________________________________________________
Do You Yahoo!?
Got something to say? Say it better with Yahoo! Video Mail
http://mail.yahoo-dot-com