Re: Flyback question

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Jonathan Peakall by way of Terry Fritz <twftesla-at-qwest-dot-net>" <jpeakall-at-madlabs.info>

Mark,

If the flyback is epoxy filled, you can use a dremel tool. If it is rubber
filled, you can just dig it out. The best flybacks will be scrounged from
older stuff though, most newer equipment seems to use lower voltages than
the old stuff. There is more flyback disassembly info on my web site.

Regards,

Jonathan Peakall

www.madlabs.info