Re: rebuilt nst not working

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Peter Lawrence by way of Terry Fritz <twftesla-at-qwest-dot-net>" <Peter.Lawrence-at-Sun-dot-com>

Bill,
     Yes, but he will end up with half the voltage at twice the current,
eg if he started with a 15-30 he would end up with a 7.5-60.

-Peter.



>
>Original poster: "Bill Vanyo by way of Terry Fritz <twftesla-at-qwest-dot-net>" 
<vanyo-at-echoes-dot-net>
>
>Just curious - if for some reason he couldn't flip one of the
>secondaries back to how it should be (like if he plasticoated them in
>place), would it be any different if he just hooked the two leads from
>the secondaries together, and used that and the NST ground as the supply
>lines to his tank circuit?
>
>	- Bill Vanyo
>
>Tesla list wrote:
>> 
>> Original poster: "Peter Lawrence by way of Terry Fritz
>?twftesla-at-qwest-dot-net?" ?Peter.Lawrence-at-Sun-dot-com?
>> 
>> Sounds like maybe you removed the secondary coils for cleaning and then
>> flipped one of them around when sliding them back on the iron core. Now
>> flip either one, not both, to return to normal.
>> 
>> -Peter Lawrence.
>> 
>> ?
>> ?Original poster: "by way of Terry Fritz ?twftesla-at-qwest-dot-net?"
>> ?steve.tami.andrews-at-att-dot-net?
>> ?
>> ?more problems......just put back together a 15000/60
>> ?france.the first dry run was ok except for some arcs
>> ?{both sides would arc to ground and each other},so i
>> ?took it back apart insulated everything..now no arc over
>> ?but both sides only arc to ground not each other?what
>> ?did i do wrong.used plasticoat to coat both sides of the
>> ?sec?i did a 15000/30 the same way it seams to be working
>> ?ok..could i have taken too many shims out? any help will
>> ?be great, thanks as allways
>> ?
>> ?
>
>
>