RE: Line filter - wiring up

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Lau, Gary by way of Terry Fritz <twftesla-at-qwest-dot-net>" <Gary.Lau-at-hp-dot-com>

If you wire your mains ground to the case of the filter, use terminals C &
D for the NST and terminals A & B for the line in.

Gary Lau
MA, USA

>Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<Hhchicken1-at-aol-dot-com>
>
>Hi list,
>I found a 15A, 250V line filter in my junkbox but the labelling on it is a 
>bit cryptic.  (http://www.hot-streamer-dot-com/temp/linefilter.jpg)  Can someone 
>tell me which of A, B, C and D are the line and load sides?  The consensus 
>was reached that it was best to put the coil on the load side, right?
>
>Thanks very much,
>
>Henry