Re: Connecting secondary

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Crow Leader by way of Terry Fritz <twftesla-at-qwest-dot-net>" <tesla-at-lists.symmetric-dot-net>

> Original poster: "Brian by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<ka1bbg-at-webryders-dot-net>
>
> Hi, no, dont drill and feed the wire thru! it will cause all kinds of
> problems...better to secure it with a small blob of epoxy. I even used
vinyl
> tape just for extra support, if anybody asks just tell them its what makes
> good sparks. cul brian f.

The Sky is Falling, you'll get eletrocuted, your house will burn down, and
tesla coiling will be banned!

I'll let everybody know when my secondaries fail because of my deviant, evil
holes. Vinyl tape does not age well. The less you rely on tape the better.
The crud from dried out tape is foul and hard to remove.

KEN

>
> ----- Original Message -----
> From: "Tesla list" <tesla-at-pupman-dot-com>
> To: <tesla-at-pupman-dot-com>
> Sent: Sunday, October 20, 2002 11:48 PM
> Subject: Connecting secondary
>
>
> > Original poster: "Matt Morrissette by way of Terry Fritz
> <twftesla-at-qwest-dot-net>" <yinzara-at-MIT.EDU>
> >
> >
> > What is the best way to secure the wire on the secondary? Should I drill
a
> > small hole in the top and bottom and feed the wire through and secure it
> from
> > the back and connect the two ends to the toroid and ground?  Also how do
I
> > connect the toroid to the secondary (both physically and electrically)?
> >
> >
> >
> >
>
>
>
>
>