Re: driving copper pipe

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Rodney Goolsby by way of Terry Fritz <teslalist-at-qwest-dot-net>" <jeronimo-at-bright-dot-net>

Just curious, what does the salt do?

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Thursday, August 07, 2003 11:33 AM
Subject: Re: driving copper pipe


 > Original poster: "Dr. Resonance by way of Terry Fritz
<teslalist-at-qwest-dot-net>" <resonance-at-jvlnet-dot-com>
 >
 >
 > Make an adapter with some radiator hose clamps to run tap pressure water
 > through your copper tubing.  It will slowly work it's way into the soil.
 > Just prior to finishing, after disconnecting hose, put a cupfull of table
 > salt down the tube.  Pull it up for 6-8 inches so the salt goes out the
 > bottom, and then repound the copper tube in all the way.
 >
 > Dr. Resonance
 >
 > Resonance Research Corporation
 > E11870 Shadylane Rd.
 > Baraboo   WI   53913
 > ----- Original Message -----
 > From: "Tesla list" <tesla-at-pupman-dot-com>
 > To: <tesla-at-pupman-dot-com>
 > Sent: Wednesday, August 06, 2003 6:00 PM
 > Subject: driving copper pipe
 >
 >
 >  > Original poster: "Rodney Goolsby by way of Terry Fritz
 > <teslalist-at-qwest-dot-net>" <jeronimo-at-bright-dot-net>
 >  >
 >  > I'm sure many of you know how hard it is to drive long pieces of copper
 >  > pipe into hard ground to make an RF ground, such as my yard which has a
 > lot
 >  > of clay in it.  I was wondering if it would be alright to fill a 5'
piece
 >  > of .5" or .75" copper pipe with quick cement to make it sturdy enough
to
 >  > pound into the ground.  If not what other method could I use to get the
 >  > pipe into the ground?
 >  >
 >  >
 >
 >
 >