[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Primary Supports - Ball Cutter Question
Original poster: Yurtle Turtle <yurtle_t-at-yahoo-dot-com>
I have a 3/8" cylindrical ball cutter for a 3/8" HDPE
primary support. I define "cheap" as less than $50.
If you check my website, you'll see my 1/4" lexan
"hard threaded" primary. Do you have any real ideas or
just talk.
Adam
--- Tesla list <tesla-at-pupman-dot-com> wrote:
> Original poster: FIFTYGUY-at-aol-dot-com
>
> In a message dated 6/11/04 9:41:19 AM Eastern
> Daylight Time, tesla-at-pupman-dot-com
> writes:
>
> > The problem is that the ball cutter I bought
> > apparently can't cut more than half way into my
> > supports.
>
> Why not?
>
> > Do ball cutters exist that would allow me to cut
> > deeper than halfway down in a single pass? If
> so,
> > where can I get one? (A cheap one.)
>
> What's your support material and thickness?
> What size ball are you
> looking for? How do you define "cheap"?
> There are easier, if not better, ways of
> securing the primary...
>
> -Phil LaBudde
>
>