Re: Waveform Generators - Any interest in BULK board / enclosure purchase ? ? ?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: Finn Hammer <f-h-at-c.dk> 

Dan,

If, apart from the function generator bit: sine square and sawtooth, it 
could do powerpulsing.
Something that could be compared to the HP 214a

http://www.helmut-singer.de/pdf/hp214a.pdf

That would be nice.

100V is perhaps exaggerating it, but otoh, an output able to handle the 
gates of IGBT bricks, etc. would be nice.

In that case, I`d be in for a couple boards.

Cheers, Finn Hammer

>  > Original poster: "Eastern Voltage Research Corporation"
><dhmccauley-at-easternvoltageresearch-dot-com>
>  >
>  > I've been thinking about designing a high quality waveform generator for
>  > sometime now and wanted to find out
>  > if there is any interest on the group for possibly a bulk board / front
>  > panel purchase.
>  >
>  > Basically, I would propose designing a PCB board and also a customized
>front
>  > panel (to fit a nice off-the-shelf Hammond enclosure box) and sell them
>  > together.
>  >
>  > The function generator would basically have:
>  > Sine Wave
>  > Square Wave
>  > Triangle Wave
>  > Pulse (adj Duty)
>  > Sawtooth Wave
>  >
>  > Initially 0-5VDC with adjustable OFFSET output with the possibility of
>going
>  > with a power stage for high voltage output.
>  > It would also be PLL synthesized with a crystal for high accuracy and
>  > possibly an LCD PIC interface.
>  >
>  > I haven't made any decisions on whether i'll do this or not, but if there
>is
>  > enough interest, i may consider pursuing it.
>  >
>  > Thanks
>  > Dan
>  >
>  >
>  >
>