[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: coil setup

To: tesla-at-pupman-dot-com
Subject: Re: coil setup
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Mon, 17 May 2004 20:08:33 -0600
Resent-Date: Mon, 17 May 2004 20:12:55 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <2wUxZB.A.LR.kEXqAB-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Eastern Voltage Research Corporation" <dhmccauley-at-easternvoltageresearch-dot-com> 

Thats not true.
There is still decoupling that occurs even in directly connected
primary/secondary systems that eliminates all the 60Hz signal from the
output.

Dan


 > For safety it's best to just ground the sec. coil and not connect it to
the
 > primary.  Otherwise deadly 60 Hz can be found on the RF output.
 >
 > Dr. Resonance

Prev by Date: RE: Coil Form needed 2
Next by Date: Re: Hmmmm...(was CDE 942c20p15k Group buy)
Prev by thread: Re: coil setup
Next by thread: Re: coil setup
Index(es):
- Date
- Thread