[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Primarky design (was capacitor help)
Original poster: "MalcolmTesla" <tesla@xxxxxxxxxxxxx>
----- Original Message -----
From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Friday, December 16, 2005 6:23 PM
> Original poster: Esondrmn@xxxxxxx
>
> Malcolm,
>
> Very nice looking primary. As long as everyone is chiming in with
> free advice - someday, you will like to have better access to the
> underside of the primary for adjusting the moveable tap lead. I have
> my primary base cut out with pie sections missing between the primary
> tubing support ribs. I see that you have holes in those areas but it
> will be hard to get your hand in there. It will be easier to cut
> more of that wood out now before you get the secondary installed.
>
> Just a thought. Keep up the good work.
>
> Ed Sonderman
Ed, thanks for the advice. I did cut holes as you noted. My secondary is
going to have a quick release setup. Bolt with a wing nut so it can be
removed/installed in a snap. I plan on taking my Tesla Coil around quite a
bit.
Thanks
Malcolm