Original poster: Finn Hammer <f-h@xxxx>
Tyler, welcome aboard.
comment inbetween:
Tesla list wrote:
Original poster: Tyler Pauly <rpggod714@xxxxxxxxx>
snip
2. Do you have any words of wisdom on constructing the primary? Mine will be 12 turns of .25 copper tubing held by HDPE cutting board. They start at 6" diam. to 17". I originally planned for 6 supports, but not only was it incredibly hard to "wind" it, but the glue holding the plastic to the board support gave out. I know glue wasn't the best idea, so I'm now routing ruts into my board to slip the strips of HDPE into. I'm kind of struggling. There's got to be an easier way to this. Any ideas?
You could go down from the top also.
Cheers, Finn Hammer
Thanks for the help, Tyler