[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Tiny DRSST was Re: Ultra tiny coils!
- To: tesla@xxxxxxxxxx
- Subject: Tiny DRSST was Re: Ultra tiny coils!
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Fri, 11 Feb 2005 12:19:52 -0700
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Fri, 11 Feb 2005 12:21:32 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <5TwHAD.A.m5D.6WQDCB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Bob (R.A.) Jones" <a1accounting@xxxxxxxxxxxxx>
If you are going to build a transistor invertor why not build a tiny DRSSTS.
The high frequency is the obvious problem. Perhaps an emitter follower in a
half bridge self resonate pulse burst configuration. Using a current
transformer for the feedback and free wheel diodes across the transistors. A
555 to control the burst width.
A fat coil and relatively large top load would drop the frequency to say a
few meg. Well within the frequency response range of emitter followers
You could run it off two PP9s.
Perhaps a single transistor with a parallel primary using a transistor they
use in 27MHz CB power boosters.
Robert
----- Original Message -----
From: "Tesla list" <tesla@xxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Friday, February 11, 2005 6:47 AM
Subject: Re: Ultra tiny coils!
> Original poster: "Jim Lux" <jimlux@xxxxxxxxxxxxx>
>
> AWG10 is basically 0.10 inches in diameter (that's 2.54 mm)
> every 6 gauges is half the diameter (so, AWG 16 is 0.050 inches in
diameter)
>
>
> ----- Original Message -----
> From: "Tesla list" <tesla@xxxxxxxxxx>
> To: <tesla@xxxxxxxxxx>
> Sent: Thursday, February 10, 2005 7:42 PM
> Subject: Re: Ultra tiny coils!
>
>
> > Original poster: Jerry White <starcatfisher@xxxxxxxxxxxxx>
> >
> > It's on the list! First I need to make my first normal size (3-4")
coil.
> By
> > the way does anyone know where I can find a mm -AWG conversion chart?
> > Jerry
> >
> > Tesla list <tesla@xxxxxxxxxx> wrote:
> > Original poster: Ed Phillips
> >
> > Tesla list wrote:
> > >
> > > Original poster: Jerry White
> > >
> > > I WANT!!!!
> >
> > Then MAKE! I plan to "when I get the time".
> >
> > Ed
> >
> >
> >
> >
>
>