RE: piglet pre-Corcom "hash inductor filters"

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: "Cameron B. Prince" <cplists@xxxxxxxxxx>

Hi,

Could you post a picture of these? I'm very interested in seeing them.

Thanks,
Cameron

> -----Original Message-----
> From: Tesla list [mailto:tesla@xxxxxxxxxx]
> Sent: Friday, June 03, 2005 12:18 AM
> To: tesla@xxxxxxxxxx
> Subject: piglet pre-Corcom "hash inductor filters"
>
> Original poster: "Jim Mora" <jmora@xxxxxxxxxxx>
>
>
>
> -----Original Message-----
> From: Tesla list [mailto:tesla@xxxxxxxxxx] Hello all,
>
> I just completed 2 line hash filters that came out very nice
> and fit nicely in an old Bank alarm vented boxed that I have
> been keeping forever for some
> reason:-)
>
> specs and a easy tip:
>
> (2) 20" 3ID PVC
> (100) 3/8" 16" mild round ((7) 20' lengths)) I had someone
> cut em...50 fit well per tube "" Available scrap
> (2) quarts marine 2 part resin epoxy
>
> Tip:(1) 3" test plug (any hardware store) ~ 2" deep Vasoline
> or grease the inner edge. Works great"
> Plug the bottom end of one tube, stuff the rods and pour in
> the epoxy. Plug comes right out finger tight on the wing nut
> when cured. Make the other form.
>
> Wind 80 turns of AGW# 10 and leave some leads! I used stranded.
>
> Inductance = 1.5 mH
> DC Ohms   =  .3
> XL	     =.57 ohms
>
> Special thanks to Dr. Resonance for his core and winding suggestions.
>
> I'll make some water heater 9000 watt tests in a couple of
> days. And get a voltage drop.
>
> Jim Mora
>