[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: metal spinning on DIY
- To: tesla@xxxxxxxxxx
- Subject: Re: metal spinning on DIY
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Thu, 09 Jun 2005 22:12:20 -0600
- Delivered-to: chip@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Thu, 9 Jun 2005 22:13:17 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <BqlH1D.A.4-.MNRqCB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Adam Clough <tesla.nz@xxxxxxxxx>
Most sources state 'Pure' aluminium is best for spinning
A nice guide on spinning can be found here:
http://prl.stanford.edu/documents/pdf/spinning.pdf
which I found when perusing fellow kiwi Bruce Simpson' great site
about PulseJets!
info on building a spinning lathe too
http://www.aardvark.co.nz/pjet/
cheers
Adam
On 6/10/05, Tesla list <tesla@xxxxxxxxxx> wrote:
> Original poster: Ed Phillips <evp@xxxxxxxxxxx>
>
> "Not so difficult. I have used aluminum, copper and brass. I prefer
> brass, since I can solder the two halves, and it looks better than
> copper.
> But aluminum is easier to work.
>
> Antonio Carlos M. de Queiroz"
>
> What type of aluminum do you use and does it require
annealing? If so,
> how can you do that?
>
> Ed
>
>
>