Original poster: "Steve Ward"
<mailto:steve.ward@xxxxxxxxx><steve.ward@xxxxxxxxx>
Hi Ken,
Will you be employing your delay register on this next attempt to try
and compensate for delays? I hope that works as expected. Be sure to
have a camera handy to take pictures of the sparks!
Good luck, let us know how it turns out.
Steve
On 3/24/06, Tesla list <mailto:tesla@xxxxxxxxxx><tesla@xxxxxxxxxx> wrote:
> Original poster: "K. C. Herrick" <mailto:kchdlh@xxxxxxx><kchdlh@xxxxxxx>
>
> I see that my last posting on this topic was in December. In the
> interim I've been slothful to a fault (altho happily busy for 3 of
> the weeks entertaining our Most Perfect Granddaughter, 2 1/2,
> visiting from Berlin). But I have now gotten to the stage where I'm
> ready to put the H.V. to it once again. I've checked the gate
> waveforms & all 4 appear OK. Next, it's... turn up the variac &
> watch for the smoke. It's only trepidation, accumulated from years &
> years of such practice, that keeps me from doing it today; So perhaps
> I'll first just sit & think about it for a while...
>
> Someone asked, after I reported my last failure (death of an IGBT
> brick), what might have caused it, and at the time I didn't
> know. But while rebuilding the drivers, I discovered that I had
> positioned a wire-wrap pin, in one of the gate circuits, so that,
> when I fastened the board down above the mains capacitors, the pin
> pressed against one of the capacitor terminals--hidden from view, of
> course. I didn't locate the source of the resultant smoke until I
> started rebuilding.
>
> As I've already reported, I utilize NPN/PNP emitter-follower
> driver-pairs for each of the 4 H-bridge IGBTs, transformer-driven,
> with the 4 transformer signals always applied (from my "pilot
> oscillator")--and now rebuilt with opto-isolators acting to gate-on
> drive to the NPNs during the spark-event times. That way, all 4 gate
> voltages are kept at -28 or so between sparks by the continuous drive
> from the PNPs. As before, the continuous transformer signal also
> serves to keep the + and - drive-supply electrolytics charged up.
>
> So stay tuned, so to speak--& don't be startled by smoke seen coming
> from the vicinity of California; it'll only be me once again.
>
> Ken Herrick
>
>
>
>
>