Brass bolt for top cap on secondary to secure toroid (fwd)

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: List moderator <mod1@xxxxxxxxxx>



---------- Forwarded message ----------
Date: Wed, 25 Oct 2006 22:40:06 -0400
From: John <guipenguin@xxxxxxxxx>
To: Tesla list <tesla@xxxxxxxxxx>
Subject: Brass bolt for top cap on secondary to secure toroid

Hello, I know most people use nylon bolts because of their
non-conductivity.... but would there be any problems with doing
something like this?

Top of cap: http://i27.photobucket.com/albums/c178/GUIPEnguin/capup.jpg
Bottom of cap: http://i27.photobucket.com/albums/c178/GUIPEnguin/capdown.jpg

When I apply a thick glob of silicone to the inner bolt, and then
silicone in a tight-fitted lexan disk? Along with a baffle at the
other end of the pipe...... this should be reasonable protection from
an internal spark using this small brass bolt right? Want to make sure
before I silicon everything tightly in place.

Thanks,
     John.