Original poster: "Cameron B. Prince" <cplists@xxxxxxxxxxxxxxxxx>
I'd like to see it...
Thanks,
Cameron
> -----Original Message-----
> From: Tesla list [mailto:tesla@xxxxxxxxxx]
> Sent: Sunday, January 21, 2007 6:03 PM
> To: tesla@xxxxxxxxxx
> Subject: Commercial VTTC
>
> Original poster: Frank <fxrays@xxxxxxxxxx>
>
> Hi all,
> I have a commercial VTTC that was rescued from the dumpster.
> It was made by Phillips and all that I can see that is wrong is the
> grid caps are shot.
> The primary and secondary was wound on clear acrylic tubing.
>
> The set is powered by 220 and uses an TB2.5/300 tube and the HV
> supply is straight AC.
>
> Apparently it was used to pre test fluorescent tubes when they were
> manufactured.
>
> After a long search I found exact replacements for the grid caps. I
> just need to clean up the potting material that leaked from the cap
> and make a control harness.
> The case could stand a repaint but not critical.
>
> I was lucky in that a schematic was found with the coil!
>
> If anyone is interested in seeing it, I can send a zip file of pix
> and the schematic. It is about 1.1 MB
>
> Thanks, Frank
>
>