Re: [TCML] Table Saw Blades for Phenolic LE

[Dave Leddon <dave@xxxxxxxxxx>]

Hi Dan,

I've cut lots of this stuff using a blade designed to cut plastic:
http://www.amazon.com/Freud-LU94M010-10-Inch-Plexiglass-Plastic/dp/product-description/B00004T7AL
Cutting phenolic on a table saw generates a fine dust that covers 
everything in your shop and also releases some amount of formaldehyde 
which, as I understand it, should not be inhaled.  So I always wheel the 
saw outside and set up a large fan at my back to blow the dust away from me.

Dave

At 04:17 PM 2/10/2008, you wrote:
> Anyone have experience with cutting LE Phenolic on a table saw.  Looking
> for a blade recommendation for nice clean cuts.
> Just acquired a truckload of this stuff from a surplus auction and
> probably going to be building lots of stuff with it!
>
> Thanks
>
> Dan
>
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla