Henry -
This sounds plausible, but do you have any actual data (scope
waveforms, etc) that would support the claim of better quenching
from a "propeller gap" vs a conventional static spark gap?
The data would have to be generated from a test setup where the only
variable was the substitution of the two different types of gaps.
If you have data, could you share it with the List?
Regards,
Scott Hanson
----- Original Message ----- From: "Henry Hallam" <hallam@xxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Thursday, February 21, 2008 9:42 PM
Subject: Re: [TCML] Spark gap
Among other things, the propeller gap is better at quenching
(shutting off the spark), especially at high power.
Henry
Rich Schmuke wrote:
I am going to ask a simple question but please give a simple answer. I am
not a EE just a builder. I was asking about a rotor gap the other
day and it
was suggested I try a propeller gap for my 200ma coil. Well I have a motor
from a 8" hard drive now and am going to build a mount as soon as
it is warm
enough to get to my shed. My question is why is a propeller at 3600 RPM
better than a RQ copper tube gap? 60 cycle RQ vs a 3600RPM it's the same
break rate I think.
Rich
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla