[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] Spark gap comparisons
Hi Matt,
The voltage is the same as well as the current dictated by the load. A
5mm gap versus five 1mm gaps in series. I expect there are probably some
variations due to arc dynamics, but I would have to guess their pretty
close. Once the arc is started, R is at a very low state, but of course
present and a voltage drop is across the arc. If the current remains
unchanged and you stretch the arc, "then" I see the arc resistance going
up, but may still not make a big difference in performance in a system
(I guess that depends on the system). Imagine a load of say 10000 ohms
with an arc resistance in series with that load of only 0.00001 ohms.
Now stretch the arc to 0.00002 ohms. It just doesn't impact the system
(in my mind). But I'm no expert, just thinking.
Take care,
Bart
Mddeming@xxxxxxx wrote:
Hi,
This brings up a very interesting question on the non-linear dynamic
resistance of spark gaps, which I have never seen addressed. If we call the
effective resistance of a gap at any instant R*, then the instantaneous power
being dissipated across each gap(x) is Px= Ex^2/R*x, Where Ex is the voltage
drop across gap(x). If we have 5 gaps, each 1 mm in width, is the sum of the
R*s, (and thus the Pxs)equal to, greater than, or less than the R* of a single 5
mm gap? Likewise, does a straight arc have the same dynamic characteristics
as an arc blown into a "U"-shape by high pressure or vacuum? I think not, but
can't prove it. This might be a worthwhile project for those who have the
time, equipment, and ability to do precise, repeated measurements.
Matt D.
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla