I did a lot of testing with my TC this past weekend. One of the things I
did this weekend was increase my top load. I resized my 6x18" toroid to
6x21". This toroid is stacked below my 7x23" toroid. When it came time to
re-tune the coil I just did it experimentally. To me performance seemed to
increase as I added more primary inductance. I had the tap at the very end
of my primary by the end of my testing. I just updated my model in JavaTC
and run the numbers today and it's telling me that I should tap 2 turns
closer to the center than I had this weekend. I tried tapping it around
where JavaTC suggests this weekend and the performance did not seem to be as
good as driving it with as much inductance as I could get out of the
primary. When I ran it near where JavaTC suggests the discharge woudl break
out in multiple small streamers. When I ran the coil with the tap all the
way at the end of the primary I would get a single breakout that went up to
56".
I'm fairly certain the numbers I've put into JavaTC are correct. They
haven't been wrong in the past. Was I running the coil out of tune, or is
there something I could be missing?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla