[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] pole pig ballasting
Scot,
Heh, heh, heh, I like the way you think ;^)
Of course, a typical residential electric
service couldn't "dish out enough" to
even come close to maxing out the po-
tential of a 50 kVA unit, though. I push
up to 90 amps at over 200 volts into my
Green Monster coil system and I use
just a 10 kVA piggie for my transformer.
It's never gotten the slightest bit warm
after even the longest high powered runs.....
David Rieben
----- Original Message -----
From: "bunnykiller" <bunnikillr@xxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Wednesday, July 16, 2008 9:12 PM
Subject: Re: [TCML] pole pig ballasting
Hey Phil...
you are correct in the 20+ sqr inches being over kill but then again, he
does own a 50KVA polepiggie... I was thinking ahead when he decides to
"use what he has" to full potential...
Scot D
FIFTYGUY@xxxxxxx wrote:
In a message dated 7/16/08 3:11:02 P.M. Eastern Daylight Time,
bunnikillr@xxxxxxx writes:
there are several methods of ballasting a piggie, the best I have seen
so far is to use an EI frame with about 18 -20 sqr inches on the middle
column for 30A worth of capacity
I made my ballast by cutting up a 3-phase 25kVA drive isolation
transformer for the metal. I made the core dimensions 3 inches by 3.5
inches. That's 10.5 square inches. My ballast core stays cool, even
during 60A runs. The windings get a little warm, but I went cheap and
used four parallel windings of 12ga THHN. My point is, 20 square inches
seems like a lot of overkill for only a 30A ballast. You shouldn't need
that much iron! Even if you used mild steel, it has a low permeability
but it takes a lot to saturate it. -Phil LaBudde
Center for the Advanced Study of Ballistic Improbabilities
**************Get the scoop on last night's hottest shows and the live
music scene in your area - Check out TourTracker.com!
(http://www.tourtracker.com?NCID=aolmus00050000000112)
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla