RE: [TCML] Rolling thin wall tubing into ribbon

["Dave Halliday" <dh@xxxxxxxxxxxxxx>]

This would work:

http://www.grizzly.com/products/12-Slip-Roll/G7148

I have a larger brother and the build quality is pretty good. You would want
to make a jig to feed the tube in straight.

Dave 

> -----Original Message-----
> From: tesla-bounces@xxxxxxxxxx 
> [mailto:tesla-bounces@xxxxxxxxxx] On Behalf Of Jim Mora
> Sent: Friday, July 18, 2008 3:05 PM
> To: tesla-bounces@xxxxxxxxxx
> Cc: 'Tesla Coil Mailing List'
> Subject: [TCML] Rolling thin wall tubing into ribbon
> 
> Hi Group,
> 
>  
> 
> Has anyone ever tried to make a jig to roll tubing through a 
> set of steel
> rollers or smooth pipe rollers spaced to take advantage of 
> flat pancake and
> retain a rounded edge to reduce corona? Ha ha, maybe a 
> flatbed and a lawn
> roller full of oil would work :-^) Rounded ribbon is expensive.
> 
>  
> 
> Jim Mora
> 
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla