[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] Looking for small Tesla Coil for sale in roughly Colorado area
I have a nice med size coil. I live in Tucson AZ during the winter months.
Contact me offlist and I will advise on my direct tel number.
Dr. Resonance
On Mon, Sep 29, 2008 at 9:26 PM, <Davetracer@xxxxxxx> wrote:
>
>
> Hi fellow mailing list members,
>
> This discuss led me to this request . . .
>
> I'm looking for a small Tesla Coil for sale in Colorado or parts reasonably
> close. I lived in Texas for a bit so distance doesn't bother me much.
>
> I'm willing to drive a ways to pick it up, so I'd definitely consider
> Nebraska, Wyoming, and so forth. I'm located in Denver, Colorado.
>
> I'd prefer a vacuum tube coil if possible, but I have nothing against
> neon-sign transformer coils. I've built both multiple 811A and 12Kv and
> 15Kv NST
> coils.
>
> Here in Denver it is hard to get parts. The good parts companies have all
> shut down, as far as I known, and Dave Fistell, of Fistell's Electronics,
> who
> was wonderful to hobbyists, passed away. The people running Fistell's now
> seem
> determined to run it into the ground. I have no idea where I would find a
> socket for an 811A without Fistell's.
>
> The reason I'm looking this way for a TC is that I've found, much to my
> annoyance, that I've developed carpal tunnel, from way too much computer
> typing.
> It crops up with a real vengeance if I do any pulling against my carpal's
> (they're the "grippers" of your fingers, so say, for example, stripping
> wire, or
> turning a crescent or torque wrench causes it to flare up). And don't even
> mention turning a coil to wind it! ...
>
> So if you have an old coil that works well and you've been wondering what
> to
> do with it, hey, drop me an email ...
>
> Thanks,
>
> Dave Small
>
>
>
>
> In a message dated 9/29/2008 8:33:34 P.M. Mountain Daylight Time,
> bartb@xxxxxxxxxxxxxxxx writes:
>
> Hi Scott,
>
> For a Halloween exhibition, 10 awg is fine. No need to go bigger for
> this type of fun with a coil. As far as the caps, I've seen them offered
> somewhere before, but I'm not aware of anyone using them in TC service.
> Experiment before hand. They may work out great. Keep an eye out for
> heat. Try a 30 second run, check for heat, and if cool, your good to go
> within reason (maybe then do a 1 minute run). If they get warm, then
> just reduce your time on. For low cost caps, you can't go wrong. Who
> knows, maybe these caps will handle TC service in long runs like the CD
> caps (kind of doubt it, but only testing will reveal the truth).
>
> Best regards,
> Bart
>
> Scott Bogard wrote:
> > Hey guys,
> > I am in the process of resurrecting my 3-in tesla coil just in time
> > for an informal Halloween presentation to the neighbors (with a number
> > of improvements, like a 4-in secondary, so it is pretty much a new
> > coil.) Anyway I have a question, I plan on using 10AWG for the tank
> > wiring (it is OBIT powered, 3 in parallel for 10kV at 69mA with 30nF
> > cap) would there be any advantage to using 1/4 inch copper tubing or
> > will some solid wire 10AWG be fine, I'm not sure which is more
> > expensive. Since this coil will be borrowing my Sync gap and nice
> > control box normally used by my larger coil, I don't want to sacrifice
> > any significant performance for a few dollars. Perhaps I should use
> > thicker wire yet, any thoughts would be appreciated. Also I am using
> > some super cheap surplus caps I found on electronic goldmine,
> > http://www.goldmine-elec-products.com/prodinfo.asp?number=G16864
> > Has anybody used these and if so how good were they, I know it is
> > dangerous to use surplus stuff but I figure they will be a step up from
> > pickle jar caps I used to use, and if they break, it didn't cost me
> > much! Thanks.
> >
> > Scott Bogard.
> >
> >
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
>
>
>
>
> **************Looking for simple solutions to your real-life financial
> challenges? Check out WalletPop for the latest news and information, tips
> and
> calculators. (http://www.walletpop.com/?NCID=emlcntuswall00000001)
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla