Re: [TCML] Re: YAY SOLIDWORKS

[DC Cox <resonance@xxxxxxxxxxxx>]

Greg:

Did you experience any interference from the RF energy into the electronic
driver controller for the motor?

And, if so, how did you solve this problem?

Dr. Resonance





On Sat, Apr 25, 2009 at 12:20 PM, Greg Leyh <lod@xxxxxxxxxxx> wrote:

> Yes, SolidWorks is great for basic design capture, even if it's not used
> for the final documentation.  Sometimes I'll play around in SolidWorks just
> to figure out how something might go together.
>
> Here's the SolidWorks model for Electrum's rotary gap system, done by Tim
> Wadlington in 1997:
>
>
> http://www.lightninglab.org/Projects/electrum/construction/pages/rtarygap.html
>
> -GL
>
>
> Andrew Robinson wrote:
>
> So I just discovered the amazingness of solid works. My new ARSG is
>> completely designed. Heres the general over picture. Everything is so
>> perfect mathmatically. If you dont have solidworks you should consider using
>> it! This'll make the work for the machinist cake.
>>
>> http://host.atomiklan.com/assembly.jpg
>>
>
>
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla