RE: [TCML] Secondary winding jig

["Richard Schmuke" <rdj@xxxxxxxxxxxx>]

Nice set up for winding , as said before it would be a little fast for me
with a 8 tube. I must ask the green stuff, it would not be a product called
Ren 1220?
Rich , KdØzz
My wife complains I mess with stuff too much but I have a "tinkering virus"



  Subject: [TCML] Secondary winding jig


  Here's my attempt at a secondary winding Jig.
<http://yfrog.com/n6coilwinderz>  I'm hoping to be able to wind up to an 8"
form on this.  The PVC on there now is 4" x 24".

  The motor is an Oriental Induction motor I got at a surplus store, and as
such it's not speed adjustable.  Though the torque is quite high - which
could be a downside if I wind up breaking wire - I'm hoping that by only
loosely afixing the PVC core to the rotating shaft (with masking tape) the
tape will give free before the wire breaks.  The gray PVC endcaps have been
turned on my lathe and fit pretty snugly, though they will slip.  Hoping
that will act as a "clutch".

  Never did this before, so this is a Version 1.0. 

  Cheers,

  Joe_______________________________________________
  Tesla mailing list
  Tesla@xxxxxxxxxx
  http://www.pupman.com/mailman/listinfo/tesla
Regards
Phil Tuck

www.hvtesla.com
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
No virus found in this incoming message.
Checked by AVG - www.avg.com 
Version: 9.0.851 / Virus Database: 271.1.1/3044 - Release Date: 08/01/10
13:40:00

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla