[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[TCML] Terry Filter Corona
HI all,
Oldbie, with a newbie question. I built a coil in the mid 70's as a school project, and at that time did not provide for any NST protection. I have always been interested in TCs so I am starting a new project 35 years later. My question is; after building the intergrated component board of my Terry filter I was looking at the underside where I made the solder connections and wondered about loosing efficiency with excessive corona. Should I attempt to coat the connections or not worry about it. Searching the Internet I have obtained a lot of information and pictures, but no pictures of the bottom of anyone's ICB. Any push in the right direction would be greatly appreciated.
Miles Mauldin
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla