Hello all,
I just measured the DC resistance of my perfectly good 15/30 and it is
0.8 ohms.
Seems like 0.7 is indeed a normal value.
Terry J
----- Original Message -----
From: "David Rieben" <drieben@xxxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Tuesday, January 19, 2010 5:34 AM
Subject: Re: [TCML] Primary short
Hi Dan,
I assume you're referring to the measured DC resistance of the
primary side of your NST? Actually, the .7 ohms sounds about
right, as the operational AC "resistance" is a function of the induc-
tive reactance of the primary coil and the frquency of the AC in-
troduced (assuming 60 hz in this case). Have you actually hooked
the NST up to 120 volts AC or whatever its rated input is? Unless
it immediately trips the service circuit breaker (or blows the fuse)
then I would say that your NST is fine.
David Rieben
----- Original Message -----
From: <ag2z@xxxxxxxxxxx>
To: <tesla@xxxxxxxxxx>
Sent: Monday, January 18, 2010 9:42 PM
Subject: [TCML] Primary short
Has anyone out there ever had a 15kv/30ma NST suddenly develop a shorted
primary during a short test? Less than one minute. The resistance of the
primary became .7 ohms. Secondary is intact on both sides. This is an old
Gardiner NST with spot welded bottom plate. Primary connections are along
the lower part of case making access very difficult. Thanks. Dan
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla