[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] Cleaning Copper Primary Coil (with Muriatic/HydrochloricAcid)
Brandon,
"I" used the zip ties. I really like the idea that others
have utilized where they notch "half-moon" holes
in the plastic supports that are at just the right size
to allow the primary tubing to be "snapped" into
place. I just don't really have the adequate tooling
to PROPERLY do it that way so that's why I set-
tled for "second best" with the zip ties.
As far as the hot glue, I suppose that would work,
too. I've just always figured that hot glue use should
be relegated to its intended purpose - arts and
crafts ;^)
David
----- Original Message -----
From: "Brandon Hendershot" <brandonhendershot@xxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Thursday, October 04, 2012 7:54 PM
Subject: Re: [TCML] Cleaning Copper Primary Coil (with
Muriatic/HydrochloricAcid)
Oh, and one more thing. Hot glue or zip ties for securing the coil?
I'm also open to other suggestions of course. Those are simply easiest
and more or less preferred. But still, your ideas are invaluable to
me, I'm always happy to hear them. ;)
Thanks for all the help,
Brandon H.
forget the steel wool and just pick up a can of Brasso from your local
dept store.
As an alternative to this, brasso is basically the
same thing minus the waxes, so get some high quality car wax, and be
prepared to use some elbow grease...
You can lacquer it when you are done (except
on the tap point) if you are really worried about it.
Steel wool seems to be the way to go. I had a brilliant man tell me
once
to apply a vary thin coat of car wax to the copper after getting the
primary situated. Seems to keep the tarnish away ;)
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla