Tim,
It's called Tufnol (in the uk anyway) I have used it for three discs so far.
As for the disc itself, I think it's a bit too small. I would prefer either
a 3600 rpm motor (easier to convert anyway - 2 flats instaed of 4) or a
bigger rotating diameter, or both.
As it's built you have little to loose though.
You wrote >>"Thank you. AT least it's something to talk about."
YES! What's happaned? A week 'off air' and everyone deserts - shamefull.
Regards
Phil T
www.hvtesla.com
-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Tim Flood
Sent: Monday, November 04, 2013 2:35 PM
To: tesla@xxxxxxxxxx
Subject: Re: [TCML] Disc Dia.
David,
Thanks for the material descriptions. I machined my disc from the phenolic,
based on your description.
Tim
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla