Thread-topic: Resin or fiberglass perfboard for terry filter?
Brian,
If the perf board has copper pads then I would stay away.
If its just holes, then It should be fine.
For the base, go to walmart and get yourself an el-cheapo nylon cutting board. =)
-Jay
----- Original Message -----
From: "Brian Gray" <armagetto@xxxxxxxxx>
To: "tesla list" <Tesla@xxxxxxxxxx>
Sent: Tuesday, September 16, 2014 9:05:38 AM
Subject: [TCML] Resin or fiberglass perfboard for terry filter?
Noob coiler here, putting together components for a 15kv NST SGTC and was
wondering if a $4 Radio Shack resin perfboard would be okay for my terry
filter? I've noticed a few people using higher quality (or at least I
assume higher quality) fiberglass perfboards and I wondered if it was maybe
because of potential heat issues with the bleed resistors or something like
that.
Brian Gray
Armagetto@xxxxxxxxx
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla