[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

arcing flyback

To: tesla@xxxxxxxxxx
Subject: arcing flyback
From: "Tesla list" <tesla@xxxxxxxxxx>
Date: Wed, 07 Feb 2007 13:40:24 -0700
Delivered-to: testla@xxxxxxxxxx
Delivered-to: tesla@xxxxxxxxxx
Old-return-path: <tcmlmod@xxxxxxxxxxxxx>
Resent-date: Wed, 7 Feb 2007 13:40:23 -0700 (MST)
Resent-from: tesla@xxxxxxxxxx
Resent-message-id: <Ba2oABTzitF.A.JcH.3kjyFB@chip1>
Resent-sender: tesla-request@xxxxxxxxxx

Original poster: khalil@xxxxxxxx

hi I'm new here. I made a ZVS flyback driver and when I try to draw arcs with
the flyback no arc forms in the place I want it to. the arc forms between 2
pins on the flyback. I know that my flyback is dead but I am wondering why it
is arcing there? is it because 2 secondary windings are floating a high
voltage? if they are then wouldn't the epoxie break down inside the flyback?

Prev by Date: RE: spark gap noise suppression
Next by Date: Re: Newcomer
Previous by thread: Re: R: Old VTTC Schematics
Next by thread: RE: synchronous motor
Index(es):
- Date
- Thread