AW: [TCML] Setting up for the first time

["Fritz W. Egli" <fritz@xxxxxxxxxxxxxx>]

Dear Doc, dear all,

How should the static gap (tank gap) to be concernet with in this process?

Question from the Swiss alps... Fritz


 Re: [TCML] Setting up for the first time

Set your total gap spacing to around .180" (180 mils), then, after tuning at
low power (50% or less) with a variac, the set final gap to approx 0.200
(200 mils).

Performance tuning includes both primary resonance tap point, and also
elevating the sec coil to set the best coeff of coupling (k factor) as
indicated by longest output spark length.  Some 1/2 inch size scrap plywood
works good for this exploration process.

In many cases the sec coil can be elevated 1-2" above the horizontal
plane of the pri coil to obtain longest spark output.

Happy sparkin'

Dr. Resonance



2008/7/17 Stephen J. Hobley <shobley@xxxxxxxxxx>:

> I'm getting close to firing up my very first Tesla coil. It uses a 12Kv
> NST, Terry filter, static gap, and MMC. When I begin, how should I set the
> gap?
>
> ...and then how should I measure performance and make adjustments for
> optimum discharge?
>
> Steve
>
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla


_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla