[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [TCML] Bleeding resistors for MMC
Ok, my caps are rated 2kV, because of the peak value.
Hopefully the resistors I'm going to buy rated 1kV will
hold.
I also found a much cheaper dealer than Elfa,
(RS-online) where I've found higher rated resistors.
Thanks for the answers!
//John
> From: zrc@xxxxxxx
> To: tesla@xxxxxxxxxx
> Date: Mon, 22 Feb 2010 19:35:56 +0100
> Subject: [TCML] Bleeding resistors for MMC
>
>
> I know this question has been brought up before, but they
> were a bit old posts and I don't know if there is anything new
> in the "Tesla world" and opinions and rules maybe have
> changed.
>
> For my 8kV 50mA NST I'm gonna have a 37,5nF MMC bank,
> with 0.1uF capacitors. If I've made the calculations right from
> the formulas I found, I need a resistor with the value 20Mohm
> and handle 3,2W. How important is this?
>
> Because I probably gonna order both the capacitors and
> resistors from Elfa, and they don't have any over 1/2W. Does
> that mean I need around 6-7 resistors over each capacitor?
>
> _________________________________________________________________
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
_________________________________________________________________
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla