Re: [TCML] Winding a secondary?

["Mark Olson" <kc5gym@xxxxxxx>]

Rob,

If I were to splice my secondary winding, and I may,
I would make the splice where it is in the lower part of the coil.

My coil has 777 turns of #17 wire on it and I would like to add
about 300 more turns.  Fortunately, my coil's construction lends
itself for this:  the coilform is long enough;  it extends through the
base of the frame by a couple of feet.  Since the top of the coil
doesn't need any modification, I plan to add the wire to the low
voltage end of the secondary and simply raise the coilform
appropriately.

Marko
KC5GYM

----- Original Message ----- 
From: "Robert Davies" <robert@xxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Thursday, September 18, 2008 8:27 PM
Subject: [TCML] Winding a secondary?


> 
> What is an acceptable method of connecting a continuation of the wire 
> for a secondary coil? example: I have a spool of 19ga magnet wire and 
> say I get 70% of the winding complete and I run out of wire, well I have 
> more of the same on another spool . I would rather buy enough wire for 
> the entire wind but I would like to use what I have.
> 
> Any Thoughts?
> 
> Rob
> 
> 
> 
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla